<tr id="oplbz"><label id="oplbz"></label></tr>

<pre id="oplbz"><label id="oplbz"></label></pre>
<li id="oplbz"><ruby id="oplbz"></ruby></li>
  • <table id="oplbz"></table>










      1.                             
        網站首頁 企業介紹 企業榮譽 產品訂單 產品中心 企業采購 聯系方式
         


        名稱:三甲基碘硅烷
         

        純度:99% 包裝:240kg/桶

        結構式
           

        CAS:  16029-98-4
        分子式:  C3H9ISi
        分子量:  200.09

        中文名稱:  三甲基碘硅烷
                           碘代三甲硅烷
                           三甲基硅基化碘

        英文名稱:  Trimethylsilyl iodide
                            iodotrimethyl-silane
                            iodotrimethylsilane
                            trimethyliodosilane
                            trimethyliodosilane(tmis)
                            iodo-trimethyl-silane

        性質描述:  可燃液體。沸點106-108℃,相對密度(20/4℃)1.41。

        用途:   主要用于脫烷基化及相關反應中的一種高效試劑,可作為一些活性基團(氨基、羥基)的保護劑,可用于頭孢的合成。

        使用注意:儲存中易變紅(主要是分解出單質碘),因此在儲存中加入銅粉。在空氣中易發煙,且使溶液發紅(原因 與水反應).

        其它信息:

        Material Safety Data Sheet
        Iodotrimethylsilane, 99% (stabilized over copper)

        Section 1 - Chemical Product and Company Identification

        MSDS Name: Iodotrimethylsilane, 99% (stabilized over copper)
        Synonyms: Trimethylsilyl iodide
        Company Identification:
        ZheJiang JuHua cregent Co Ltd

        Section 2 - Composition, Information on Ingredients

         

        CAS#
        Chemical Name
        Percent
        EINECS/ELINCS
        16029-98-4
        IODOTRIMETHYLSILANE
        99%
        240-171-0

         

        Section 3 - Hazards Identification

         
        EMERGENCY OVERVIEW
        Appearance: clear very slight brown liquid. Flash Point: -31 deg C.
        Danger! Water-reactive. Causes eye and skin burns. Causes digestive and respiratory tract burns. Flammable liquid and vapor.
        Target Organs: None known.

        Potential Health Effects
        Eye: Causes eye burns.
        Skin: Causes skin burns.
        Ingestion: Causes gastrointestinal tract burns.
        Inhalation: Causes chemical burns to the respiratory tract. Aspiration may cause respiratory swelling and pneumonitis.
        Chronic: Not available. None

        Section 4 - First Aid Measures


        Eyes: Immediately flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical aid immediately.
        Skin: Get medical aid immediately. Immediately flush skin with plenty of water for at least 15 minutes while removing contaminated clothing and shoes.
        Ingestion: Do not induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Get medical aid immediately.
        Inhalation: Get medical aid immediately. Remove from exposure and move to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen.
        Notes to Physician: Treat symptomatically and supportively.

        Section 5 - Fire Fighting Measures

        General Information: Containers can build up pressure if exposed to heat and/or fire. As in any fire, wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. Vapors can travel to a source of ignition and flash back. Flammable liquid and vapor. Reacts with water to form explosive hydrogen gas.
        Extinguishing Media: Use carbon dioxide or dry chemical. DO NOT USE WATER!
        Flash Point: -31 deg C ( -23.80 deg F)
        Autoignition Temperature: Not available.
        Explosion Limits, Lower: Not available.
        Upper: Not available.
        NFPA Rating: Not published.

        Section 6 - Accidental Release Measures

        General Information: Use proper personal protective equipment as indicated in Section 8.
        Spills/Leaks: Absorb spill with inert material (e.g. vermiculite, sand or earth), then place in suitable container. Remove all sources of ignition. Use a spark-proof tool.

        Section 7 - Handling and Storage

        Handling: Wash thoroughly after handling. Use only in a well-ventilated area. Ground and bond containers when transferring material. Use spark-proof tools and explosion proof equipment. Do not get in eyes, on skin, or on clothing. Empty containers retain product residue, (liquid and/or vapor), and can be dangerous. Keep container tightly closed. Keep away from heat, sparks and flame. Do not ingest or inhale. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose empty containers to heat, sparks or open flames.
        Storage: Keep away from heat, sparks, and flame. Keep away from sources of ignition. Store in a tightly closed container. Keep under a nitrogen blanket. Store in a cool, dry, well-ventilated area away from incompatible substances.

        Section 8 - Exposure Controls, Personal Protection

        Engineering Controls: Use adequate general or local exhaust ventilation to keep airborne concentrations below the permissible exposure limits.
        Exposure Limits

        Chemical Name
        ACGIH
        NIOSH
        OSHA - Final PELs
        IODOTRIMETHYLSILANE
        none listed
        6 mg/m3 TWA (listed under Silica, amorphous).3000 mg/m3 IDLH (listed under Silica, amorphous).
        none listed

        OSHA Vacated PELs: IODOTRIMETHYLSILANE: No OSHA Vacated PELs are listed for this chemical.
        Personal Protective Equipment
        Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166.
        Skin: Wear appropriate protective gloves to prevent skin exposure.
        Clothing: Wear appropriate protective clothing to prevent skin exposure.
        Respirators: Follow the OSHA respirator regulations found in 29 CFR 1910.134 or European Standard EN 149. Use a NIOSH/MSHA or European Standard EN 149 approved respirator if exposure limits are exceeded or if irritation or other symptoms are experienced.

        Section 9 - Physical and Chemical Properties

        Physical State: Liquid
        Appearance: clear very slight brown
        Odor: Not available.
        pH: Not available.
        Vapor Pressure: Not available.
        Vapor Density: Not available.
        Evaporation Rate: Not available.
        Viscosity: Not available.
        Boiling Point: 106 deg C @ 760.00mm Hg
        Freezing/Melting Point: Not available.
        Decomposition Temperature: Not available.
        Solubility: reacts
        Specific Gravity/Density:1.4060g/cm3
        Molecular Formula: C3H9ISi
        Molecular Weight: 200.10

        Section 10 - Stability and Reactivity

        Chemical Stability: Not available.
        Conditions to Avoid: Incompatible materials, ignition sources, excess heat, exposure to moist air or water.
        Incompatibilities with Other Materials: Strong oxidizing agents, strong acids, strong bases, reacts violently with water..
        Hazardous Decomposition Products: Carbon monoxide, carbon dioxide, silicon dioxide, hydrogen iodide.
        Hazardous Polymerization: Will not occur.

        Section 11 - Toxicological Information

        RTECS#:      
        CAS# 16029-98-4 unlisted.
        LD50/LC50: Not available.
        Carcinogenicity:
        CAS# 16029-98-4: Not listed by ACGIH, IARC, NTP, or CA Prop 65.
        Epidemiology: No data available.
        Teratogenicity: No data available.
        Reproductive Effects: No data available.
        Mutagenicity: No data available.
        Neurotoxicity: No data available.
        Other Studies:

        Section 12 - Ecological Information

        No information available.

        Section 13 - Disposal Considerations

        Chemical waste generators must determine whether a discarded chemical is classified as a hazardous waste. US EPA guidelines for the classification determination are listed in 40 CFR Parts 261.3. Additionally, waste generators must consult state and local hazardous waste regulations to ensure complete and accurate classification.
        RCRA P-Series: None listed.
        RCRA U-Series: None listed.

        Section 14 - Transport Information

         

         
        US DOT
        Canada TDG
        Shipping Name:
        FLAMMABLE LIQUIDS, CORROSIVE, N.O.S.
        FLAMMABLE LIQUID CORROSIVE NOS (IODOTRIMETHYLSILANE)
        Hazard Class:
        3
        3(8)
        UN Number:
        UN2924
        UN2924
        Packing Group:
        II
        II

         

        Section 15 - Regulatory Information

        US FEDERAL

        TSCA
             CAS# 16029-98-4 is listed on the TSCA inventory.
        Health & Safety Reporting List
             None of the chemicals are on the Health & Safety Reporting List.
        Chemical Test Rules
             None of the chemicals in this product are under a Chemical Test Rule.
        Section 12b
             None of the chemicals are listed under TSCA Section 12b.
        TSCA Significant New Use Rule
             None of the chemicals in this material have a SNUR under TSCA.
        CERCLA Hazardous Substances and corresponding RQs
             None of the chemicals in this material have an RQ.
        SARA Section 302 Extremely Hazardous Substances
             None of the chemicals in this product have a TPQ.
        Section 313      No chemicals are reportable under Section 313.
        Clean Air Act:
             This material does not contain any hazardous air pollutants.
             This material does not contain any Class 1 Ozone depletors.
             This material does not contain any Class 2 Ozone depletors.
        Clean Water Act:
             None of the chemicals in this product are listed as Hazardous Substances under the CWA.
             None of the chemicals in this product are listed as Priority Pollutants under the CWA.
             None of the chemicals in this product are listed as Toxic Pollutants under the CWA.
        OSHA:
             None of the chemicals in this product are considered highly hazardous by OSHA.
        STATE
             CAS# 16029-98-4 can be found on the following state right to know lists: California, (listed as Silica, amorphous), New Jersey, (listed as Silica, amorphous), Pennsylvania, (listed as Silica, amorphous), Minnesota, (listed as Silica, amorphous), Massachusetts, (listed as Silica, amorphous).

        California Prop 65

        California No Significant Risk Level: None of the chemicals in this product are listed.


        European/International Regulations

        European Labeling in Accordance with EC Directives
        Hazard Symbols:
             F C
        Risk Phrases:

             R 11 Highly flammable.
             R 34 Causes burns.
        Safety Phrases:

             S 16 Keep away from sources of ignition - No smoking.
             S 25 Avoid contact with eyes.
             S 36/37/39 Wear suitable protective clothing, gloves and eye/face
             protection.
             S 45 In case of accident or if you feel unwell, seek medical advice
             immediately (show the label where possible).

        WGK (Water Danger/Protection)

             CAS# 16029-98-4: 1
        Canada - DSL/NDSL
             CAS# 16029-98-4 is listed on Canada's NDSL List.
        Canada - WHMIS
             This product has a WHMIS classification of B2, E, F.
        Canadian Ingredient Disclosure List
             CAS# 16029-98-4 (listed as Silica, amorphous) is listed on the Canadian Ingredient Disclosure List.

        Section 16 - Additional Information

        MSDS Creation Date: 12/12/2003


        選購說明:
        1、歡迎選購本公司產品,撥打電話后,我們會為您送貨上門,并提供滿意的銷售服務。
        2、本公司三甲基碘硅烷價格實惠,質量可靠,出庫時可提供質檢報告和三甲基碘硅烷廠家說明書等資料。

         
        衢州明鋒化工有限公司          Copyright ©2020       技術支持:瑞爾豐化工網
        亚洲欧洲中文日韩乱码av